EzOSD 10hZ 100A

the new, highly advanced EzOSD from Immersion RC. This OSD has been talked
about for a while and many of us have seen the wonders this OSD does with the tracking antenna.
 Developed by a perfectionist from Holland, this OSD has been tested in all kinds of conditions
 and made plug and play with the Airwaves or ImmersionRC 500mW transmitter
and the RCV922 Aviator Edition set from Fatshark.
 The EzOSD is for the plug in and go flying. No hassle setup, no hard choices, just plug it in and fly.

The OSD will pass through the +5V power supplied by the transmiter and to the camera.
If you'd like to use 12V cameras and transmitters that can be done also.
please check your manual carefully for options.

Supplied with 
1 x 20cm 5pin molex/tinned power cable
1 x 24cm 5pin/5pin Molex cable
1 x 24cm 4pin/4pin Molex cable
1 x 24cm 2pin/2pin Molex cable
1 x 25cm GPS cable
1 x 45mm GPS cable