• Home
• Electronics
• Radios tx, rx and parts
• Transmitters and radios
• RadioLink
• R6DSM 2.4G 10CH DSSS FHSS RX AT9 AT9S AT10 AT10Ⅱ PPM SBUS

Earn Reward Points: 16

Earn Discount: €0.29

R6DSM 2.4G 10CH DSSS FHSS Receiver for AT9 AT9S AT10 AT10Ⅱ
PPM SBUS Output.

Radiolink R6DSM, 2.4G, 10 channels receiver, DSSS and FHSS, 1 GHz, SBUS and PPM
signal support, use for Radiolink transmitters AT9, AT9S, AT10 and AT10II,
is the best choice for racing drone.

Two signal working mode:
Blue / purple LED, SBUS signal, 10 channels totally.
Red LED always, PPM signal, 10 channels totally.

SBUS and PPM signalChange:
Short press the ID SET switch, the SBUS to PPM.The red LED indicates
the PPM and blue / purple indicates SBUS.

How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R6DSM.
3. There is a black button on the R6DSM, press the binding button twice in two seconds
and release,receiver light start blinking, after about 8 times blinking,

Installment of receiver antenna:
1. The antenna must be as straight as possible.Otherwise it will reduce the effective range.

2. Large model aircraft interfering signal;in this case the antennas should be
placed at both sides of the model.Then the best RF signal condition is obtained
at any flying attitude.

3. The antennas must be kept away from conductive materials, such as metal and
carbon by at least a half inch.The coaxial part of the antennas does not need to follow these
guidelines, but do not bend it in a small radius.

4. Keep the antennas away from the motor, ESC, and other noise sources as much as possible.

5. Press and hold the EasyLink (ID SET) one second, now the receiver starts work.

6. After all of the above steps, the LED indicator will turn and keep in red.

7. The receiver can be packed by sponge or foam.

 After all of the above steps finished, turn off the transmitter and then power it on.

Technical Parameters:
1) Channels: 10 channels
2) Working voltage: 4.8-6V
3) Working current: 38-45mA (input voltage: 5V)
4) Size: 15 * 13 MM
5) Weight: 1g
6) Detachable antenna
7) 4096 section precision, 0.25us per section, servo anti-shake rudder.
8) Control distance: about 600 meters, actually control distance
depends on the environment.