• Home
• Electronics
• Autopilot & flight controllers
• SP Racing F3 Flight Controller Acro version for racing / acro flying 6 DOF

Earn Reward Points: 35

Earn Discount: €0.63

SP Racing F3 Flight Controller Acro version for racing / acro flying 6 DOF

The SPRacingF3 gives you all the features you need for the heart of your aircraft,
Whether you're into FPV racing, acrobatic flying or aerial photography it's perfect.
Supports a variety of aircraft, tricopters, quadcopters, hexacopters, octocopters,
planes and more.

Acro Version have 6 DOF while Deluxe version HAS 10 DOF,
zoals Barometer and Compass: Additional sensors for altitude and direction

The SPRacingF3 runs the open source Clean Flight Flight Control (FC) software-which
HAS an ever-growing community of friendly users and developers.
Being open source Means That You too can Contribute to the system.

Clean Flight comes with a detailed manual that's reviewed and maintained
by the Clean Flight developers and community.No more out-of-date wiki pages
and second-hand information.

features:
        Practical - Easy access to connectors and solder pads.
        Configurable - Choose to use connectors, solder pads or pins.
        Stackable - Mount to your PDB or OSD.
        Compact - Only 36x36mm.
        Professional - Symmetrical, Neat and Tidy.
        8 Dedicated PWM outputs
        8 PWM Inputs
        36 I / O Connections
        72Mhz Clock Speed
        3 Hardware Serial Ports
        64Mb Flash Storage

Specifications (Acro Version):
The hardware was designed by the lead developer of Clean Flight to be
more capable than the previous-generation STM32F1-based boards after hearing
feedback from the Clean FlightCheck users, contributors and top pilots.
   36x36mm board with 30.5mm mounting hole
    Weight ~ 6 grams
    Acro version is without Compass and Barometer Sensors
    STM32F303 CPU, FPU 72Mhz Inc.
    High-Capacity Flash (Acro and Deluxe)
    MPU6050 accelerometer / gyro
    MicroUSB socket
    2x 8pin JST-SH sockets (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
    8x 3pin though hole for pin headers for ESC / Servo connections
    2x 4pin though hole for pin headers for 2x serial ports
    1x 2pin though hole for pin headers for battery voltage
    1x 2pin though hole for pin headers for buzzer
    1x 4pin JST-SH socket for I2C
    1x 4pin JST-SH Socket for SWD debugging

Flight Performance:
SPRacingF3 builds on the tried and tested software, processor and sensor technology
to make your aircraft fly like it's on rails.

No-Compromise I / O:
Use all the features all the time;e.g. Connect your OSD + Smart Port + SBus + GPS +
LED Strip + Battery Monitoring + sonar + 8 engines - all at the same time!

configurable:
The SPRacingF3 runs Clean Flight-which can be configured to suit your needs using a
cross-platformGUI (Windows / OSX / Linux).

Tiny and lightweight:
The SPRacingF3 Has A standard 36x36mm form factor with 30.5mm mounting hole and
weighs just 6 grams.

Flight Logging:
On-board high-capacity black box flight recorder log - Optimize your tuning and see the
results of your setup without guesswork.

Next-Generation CPU:
The SPRacingF3 HAS an ARM Cortex-M4 72Mhz CPU with math co-processor
(FPU) for efficient flight calculations That gets more done in less time.
Walk up to Times ~ 2x as fast as previous-generation STM32F1 based boards.

Developer Friendly:
Developer friendly debugging port (SWD) and boot mode selection, unbrickable bootloader.

OneShot ESC:
Full support for OneShot ESCs for easy tuning PID and a sharper response.

Broad RC receiver Support:
Supports SBus, SumH, SumD, Spektrum1024 / 2048, XBus, PPM, PWM receivers.
No external inverters required (built-in).

Programmable LED:
Dedicated output for programmable LEDs - great for orientation, race and night flying.

Battery Monitoring:
Battery monitoring ports for voltage and current.

Sonar:
Sonar support for precision low-altitude hold.

I2C Port:
I2C port always powered, perfect for external sensors or always-on OLED Screen.

buzzer:
Postage buzzer for audible warnings and notifications.