• Home
• Electronics
• Antennas & tracking systems
• Antenna tracking systems
• MyFlyDream Antenna tracking
• MFD Crossbow heavy duty

Earn Reward Points: 979

Earn Discount: €17.62

MyFlyDream Crossbow AAT


Compatible with MFD Crosshair/MFD AP or other any system
that supports Mavlink protocol.



Crossbow AAT is designed for use with unmanned aerial vehicle (UAV)
onboard antenna system.Its purpose and objective is topoint the antenna precisely in
 the current direction of the aircraft thus allowing the video receiver to pick up the
strongest signal possible at given distance and other factors.
In order to obtain better signal reception quality, it is advised to use high-gain
receiving antennas. High-gain antennas are known for very narrow angles of
effective reception.

For its successful operation, Crossbow AAT requires the flight data such as
latitude and longitude of the tracked target (UAV) at every given moment, as well as
its altitude.


This is achieved by the following:

1. Transmitting information of the tracked target over a wireless analog video link
from the UAV to the ground station. For that, the UAV must be equipped either by a
MFD Auto Pilot, or a MFD Crosshair Auto Pilot, or in case a third party AP is used,
an MFD TeleFlyPro tracking module.

ATTENTION: Using TeleFlyPro module is possible with some third party flight
controllers. MFD does not guarantee its work with any particular make or model of
the autopilot, nor that it will continue to work with any third party autopilot after its
firm- or software is updated.

2. Transmitting information of the tracked targetover awirelessHigh
Definitionvideo link from the UAV to the ground station. For that, the UAV must be
equipped either by a MFD Auto Pilot, or a MFD Crosshair Auto Pilot,
or a MAVLinkcompatible Auto Pilot, or in case a third party AP is used, an MFD
TeleFlyPro tracking module. The signal containing encoded tracking data from
the TeleFlyPro moduleon the aircraft will be transmitted to the Crossbow
AAT through the serial port .

3. Transmitting information of the tracked targetover awirelessdigital data link
from the UAV to the ground station.
MAVLink protocol allowsto transmittheinformation from theUAV through the
digital radio link. If the on-board system already includes the digital radio, andthe
flight controller thatsupports MAVLink protocol, Crossbow AAT will be able to receive
all flight information necessary to track the UAV through the sharedTX line of
the digital radio station.

4. For more specific applications requiring custom design of the signal
transmission, please contact us directly.



GPS+Compass module for Crossbow AAT.
With this plug-and-play module you don't need to set home position for your Crossbow AAT.
And you can move your tracker and keep tracking even when the plane is flying.