• Home
• Electronics
• Radios tx, rx and parts
• Transmitters and radios
• RadioLink
• RadioLink AT9-R9DS R9DS 2.4GHz 9CH DSSS Receiver For AT9 AT10 Transmitter

Earn Reward Points: 19

Earn Discount: €0.34

RadioLink AT9-R9DS R9DS 2.4GHz 9CH DSSS Receiver
For AT9 AT10 Transmitter

Product Features:
 Radiolink R9DS, 2.4G 10 channel receiver, DSSS and FHSS spread spectrum
working synchronously, use for Radiolink transmitters AT9, AT9S and AT10.

 SBUS and PWM signal possible working at the same time.

Two signal working mode:
(1) PWM signal output working mode: red LED indicates PWM signal output,
9 channels Totally.

(2) SBUS signal output working mode: blue / purple LED indicates SBUS signal
output, 10 channels total.SBUS and PWM signal possible working at the same time
with SBUS signal output working mode.CH9 output SBUS signal, the original CH1 to
CH4 output CH7 to CH10 PWM signal at the same time.

SBUS and PWM signal change：
Short press the ID SET switch two times within 1 second, the signal is changed
from normal PWM to SBUS. The red LED indicates the normal PWM and blue/purple
LED indicates SBUS signal.

How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R9DS.
3. Connect CH3 or R9DS to ESC.
4. There is a black button on the R9DS, press the button twice in two seconds
and release, receiver light start flashing, after about 8 times blinking, match code
success when receiver signal LED always on!

Installment or receiver antenna:
1.The antenna must be kept as straight as possible.Otherwise it will reduce the effective range.

2.Large model aircraft may of some metal part interfering signal;in this case
the antennas should be placed at both sides of the model.Then the best RF signal
condition is obtained at any flying attitude.

3.The antennas must be kept away from conductive materials such as metal
and carbon by at least a half inch.The coaxial part of the antennas does not need to
follow these guidelines, but do not bend it in a small radius.

4.Power the antennas away from the engine, ESC, and other
noise sources as much as possible.

5.Press and hold the Easy Link (ID SET) one second, now the receiver starts work.

6.After all of the above steps finished, the LED indicator will turn and keep in red.

7.The receiver can be packed by sponge or foam for shocking
proof when it is installed to the model.

After all of the above steps finished, turn off the transmitter and then power it on,
now the program functions to assure it under control of transmitter with
a right connection.


Technical Parameters:

 1) Channels:
   9 channels: output 9 channels PWM signal, with red LED.
   10 channels: output 10 channel signal, support SBUS and PWM signal
output synchronously, with blue LED.

2) Working voltage: 4.8-10V

3) Working current: 38-45mA (input voltage: 5V)

4) Size: 43 * 24 * 15 MM

5) Receiver integrate telemetry sensor including signal strength and voltage.
Support extended engine voltage telemetry module PRM-01 and module PRM-02 can
feedback GPS info, Speed, voltage etc. on AT9 / AT9S / AT10 display when working
with flight controller APM or PIX.

6) 4096 section precision, 0.25us per section, servo anti-shake rudder.

7) MINI receiver, just need one cable if use SBUS signal.